Filter
Top Products
®
Pelco World Headquarters • 3500 Pelco Way, Clovis, California 93612-5699 USA
USA & Canada: Tel: 800/289-9100 • Fax: 800/289-9150
International: Tel: 1-559/292-1981 • Fax: 1-559/348-1120
www.pelco.com
ADDENDUM
Addendum No.: C2900MB-ADDEN
Date: October 15, 2003
Manual Affected: PelcoNet
™
Multimedia Transmission Via Networks –
NET104A Series – C2900M-B
Manual Update: In the NOTE in the
Specifications
section, replace
“NETRANS4” with “NETPLUG4” as the replacement
transformer.
In Appendix B – Frequently Asked Questions (FAQs),
replace the answer to question 10 with the follow-
ing paragraph.
Yes. You must have Genex Version 4.1 or higher for Genex units manufactured
before November 22, 2002—or Version 1.12 or higher for units manufactured
on or after that date. (The version numbering was restarted in 2002, which is
why newer units have a smaller version number.) These versions let you
connect a KBD4000 to the Genex COM IN port and PelcoNet to the Genex
COM OUT port. This gives you both local and remote control. Refer to
Connecting PelcoNet to the COM OUT RS-422 Port on a Genex Multiplexer
in
Appendix A for detailed information.
®
Pelco World Headquarters • 3500 Pelco Way, Clovis, California 93612-5699 USA
USA & Canada: Tel: 800/289-9100 • Fax: 800/289-9150
International: Tel: 1-559/292-1981 • Fax: 1-559/348-1120
www.pelco.com
ADDENDUM
Addendum No.: C2900MB-ADDEN
Date: October 15, 2003
Manual Affected: PelcoNet
™
Multimedia Transmission Via Networks –
NET104A Series – C2900M-B
Manual Update: In the NOTE in the
Specifications
section, replace
“NETRANS4” with “NETPLUG4” as the replacement
transformer.
In Appendix B – Frequently Asked Questions (FAQs),
replace the answer to question 10 with the follow-
ing paragraph.
Yes. You must have Genex Version 4.1 or higher for Genex units manufactured
before November 22, 2002—or Version 1.12 or higher for units manufactured
on or after that date. (The version numbering was restarted in 2002, which is
why newer units have a smaller version number.) These versions let you
connect a KBD4000 to the Genex COM IN port and PelcoNet to the Genex
COM OUT port. This gives you both local and remote control. Refer to
Connecting PelcoNet to the COM OUT RS-422 Port on a Genex Multiplexer
in
Appendix A for detailed information.