Filter
Top Products
50 C2900M-B (1/03)
Table D. Video Settings (Continued)
Configuration Default Setting Description
Item
Video Priority ActiveX This field controls whether performance of the device
is optimized for MJPEG or ActiveX (H.261/H.263).
If you select MJPEG mode, a sequence of still images
(for example, a fresh image every second) is
displayed in the browser. This setting does not
require any plug-ins or ActiveX installation and may
be advisable for severely limited channels (for
example, the Internet).
PelcoNet recommends choosing ActiveX for best
video performance. This provides the best quality and
lowest data rate consumption. When you choose this
the first time, the corresponding ActiveX is down-
loaded automatically to your PC from the Pelco home
page.
Video bandwidth 1000 This field controls the transmitter bandwidth setting
ActiveX for live video. This value relates only to the video
transmission rate (without audio and protocol).
Receivers can log into the transmitter with a lower or
same data rate.
In streaming mode, this value indicates the data
transmission rate of the video. Select a video
transmission rate between 10 Kb/sec and 1 Mb/sec.
Network interface 1000 This field lets you adjust the maximum data rate that
bandwidth will be sent over the network.
Enter the data transmission rate in kbits per second.
Valid entries are 10 through 1000.
The value is the maximum bandwidth for the video
data. Also, transmission bandwidth is needed for
data; to control cameras, for example. Therefore, an
actual transfer value can be over or under the
adjusted value.
Camera 1-4 names n/a Enter the desired camera names (nine characters
maximum for each). Camera 1 is video 1 input. In
addition to the unit name, the camera names help the
user identify the locations or the visible scenes.
(Continued on next page)