Pelco C2900M-B(1/03 Home Theater Server User Manual


 
C2900M-B (1/03) 91
VIDEO 1
VIDEO 2
VIDEO 3
VIDEO 4
AUDIO IN
AUDIO OUT
INPUTS
OUTPUTS
RS-232/422/485
ETHERNET 10/100 BASE-T
POWER
PELCONET TRANSMITTER
9600, 8, ODD, 1
PELCONET DB9
ADAPTER
GENEX COM IN
RJ-45 CONNECTOR
TX+
TX-
RX+
RX-
1
2
8
7
18
GENEX COM
IN OUT
TO NETWORK
18
1
2
3
4
8
7
6
5
TX+
TX-
RX+
RX-
DB9
STRAIGHT
CABLE
RX+
RX-
TX+
TX-
CONNECTING PELCONET TO THE COM IN RS-232 PORT ON A GENEX
MULTIPLEXER
Refer to Figure 42 and the instructions that follow.
Figure 42. Connecting PelcoNet to Genex Using the COM IN RS-232 Port
Verify that the multiplexer has Version 4.1 firmware. (The version number flashes on the
monitor when power is applied to the multiplexer.)
Set the NET104A data port to Transparent, 9600 baud, 8 data bits, none (for parity), 1 stop
bit, RS-232, and half duplex mode off if it is not so set already.
Create a cable using the above diagram.
Attach the cable’s DB9 connector end to PelcoNet’s data port. Connect the cable’s RJ-45
connector end to COM OUT on the back of the multiplexer.
Connect the MAIN video output from the multiplexer to the NET104A transmitter.
Connect PelcoNet’s Ethernet port to the network using a Cat5 Ethernet patch cable.