Filter
Top Products
C626M-C (5/06) 179
BEFORE YOU BEGIN
Ensure that the following requirements have been met before starting the Emergency Agent application:
1. Make sure there is at least one active DX8000 Series DVR available on your network and your computer is set up to access it. Consult your
network administrator for more information.
2. Install the DX8000 Emergency Agent application on your computer if you have not done so already. Refer to Installing the Client Emergency
Agent Application on page 241 for instructions.
3. Make sure that Emergency Agent notification is set up on one or more DX8000 Series DVRs, and that your PC has been selected to receive
emergency notifications. For information about setting up Emergency Agent notification, refer to the Emergency Notification Setup section
in the Operation and Programming Manual.
4. Make sure IPSec security services are installed and enabled on your PC. For more information, refer to Installing the Client Emergency
Agent Application on page 241 and Enabling IPSec Security Services on page 243.
STARTING THE CLIENT EMERGENCY AGENT
To start the emergency agent software on a client PC:
1. Turn on your PC and wait while Windows loads.
2. Double-click the Emergency Agent icon on the client computer’s desktop.
Figure 145. Emergency Agent Icon
The Emergency Agent dialog box opens.
Figure 146. Client Emergency Agent Dialog Box