Filter
Top Products
C626M-C (5/06) 229
4. To adjust camera lens features, click the plus (+) or minus (-) buttons next to each function on the keypad. Refer to the following figure.
Figure 221. Web Client PTZ Lens Controls
PTZ Presets
A preset is a user-defined camera position using pan and tilt, zoom, and focus commands. A DX8000 Series DVR can address up to 128 PTZ
presets (1-32). Preset 95 is reserved for remote camera setup, and preset 99 is reserved for camera autoscan mode.
Only cameras that support positioning and programming using D, P, or Coaxitron protocols can use this feature.
NOTE: Observe the use of the icon for presets, preset tours, and patterns as follows:
• To program or clear presets, preset tours, and patterns, the Set icon must be engaged.
• To activate presets, tours, and patterns, the Set icon must be disengaged.
Programming a Preset
Clicking the icon places DX8000 in PTZ programming mode. While in PTZ programming mode, multiple presets can be programmed until
the icon is pressed again.
To program a PTZ preset:
1. Drag a camera from the Site tree onto a view panel.
2. Click .
ᕤ