Filter
Top Products
232 C626M-C (5/06)
Clearing a Preset
To clear a preset:
1. Click to enter programming mode.
2. Click the number of the preset you want to clear from the PTZ keypad.
3. Click .
4. Repeat steps 2 and 3 to clear multiple presets.
5. Click to exit programming mode.
Figure 226. Clearing a Preset Using Web Client
PTZ PATTERNS
A pattern is a user-defined, viewable camera path with a definite beginning and end. Patterns are made up of a sequence of standard pan, tilt,
and lens commands. Patterns are stored in the internal memory of the PTZ device, such as a Spectra dome, that is connected to the DX8000.
Depending on the type and configuration of the PTZ device, the DX8000 can address up to four unique PTZ patterns. Once defined, a pattern can
be activated with a series of on-screen commands. A pattern will run continuously until it is deactivated.
Only PTZ-enabled cameras that support pattern programming through D, P, or Coaxitron protocols can use this feature.
This section describes how work with patterns and includes the following topics:
• Programming a Pattern on page 297
• Activating a Pattern on page 298
• Clearing a Pattern on page 298
• Accessing Programming Features of Remote Cameras on page 299
Programming a Pattern
To program a pattern:
1. Drag a camera from the Site tree onto a view panel.
2. Click to enter programming mode.
3. Using the PTZ keypad, select a number for the pattern (1 to 4).
4. Click .
5. Move the camera through a series of movements using the on-screen pan and tilt, zoom, and focus controls.
Certain PTZ devices, like Pelco’s Spectra Series domes, will display an on-screen message stating the amount of remaining memory
available for pattern programming.
ᕡ
ᕢ
ᕣ