Filter
Top Products
52 C626M-C (5/06)
PTZ PRESETS
A preset is a user-defined camera position using pan and tilt, zoom, and focus commands (camera’s auto focus option must be off). Only cameras
that support positioning and programming using D, P, or Coaxitron protocols can use this feature. The DX8000 Series DVR can address up to 32
PTZ presets (1-32). Preset 95 is reserved for remote camera setup, and preset 99 is reserved for camera autoscan mode.
The following PTZ operating guidelines must be observed:
• To program or clear presets, preset tours, and patterns, the icon must be engaged.
• To activate presets, tours, and patterns, the icon must be disengaged.
This section describes how to program, activate, and clear presets and includes the following topics:
• Programming a Preset on page 64
• Activating a Preset on page 65
• Clearing a Preset on page 66
PROGRAMMING A PRESET
This section describes how to program a preset. The following PTZ operating guidelines apply:
• Clicking the icon places DX8000 in PTZ programming mode.
• While in PTZ programming mode, multiple presets can be programmed until the icon is pressed again.
To program a PTZ preset:
1. On the DX8000 toolbar, click .
2. Drag a camera from the Site tree onto a view panel.
3. Click .
4. Using the on-screen PTZ controls and PTZ keypad, move the camera to the desired position and adjust the zoom setting.
Figure 33. Creating a Preset
EXIT