Filter
Top Products
C626M-C (5/06) 61
CONFIGURING PRESET TOURS
A preset tour allows a camera to move through a programmed sequence of PTZ presets. The DX8000 Series DVR can store up to four preset
tours. While four tours can be programmed, only one tour can be activated at a time. A preset tour will operate continuously until another PTZ
control action is performed. At least one PTZ preset must be set in order to create a preset tour.
This section describes how to configure preset tours and includes the following topics:
• Programming a Preset Tour on page 73
• Activating a Preset Tour on page 76
• Deactivating a Preset Tour on page 76
PROGRAMMING A PRESET TOUR
This section describes how to program a preset tour and includes the following topics:
• Accessing a Preset Tour Group on page 73
• Adding Presets to a Tour on page 74
• Deleting Presets from a Tour on page 75
Accessing a Preset Tour Group
To access the “Preset tour group” dialog box:
1. On the DX8000 toolbar, click .
2. On the DX8000 keypad, click and then on the PTZ keypad. The Preset tour group dialog box opens.
3. Select the preset tour (1-4) that you want to program from the drop-down box.
4. Do one of the following:
• To add presets to a tour, refer to Adding Presets to a Tour on page 74.
• To delete presets from a tour, refer to Deleting Presets from a Tour on page 75.
Figure 45. Preset Tour Dialog Box
ᕣ