Filter
Top Products
11
INSTALLATION AND CONNECTION
4. Connecting & Running
4.1. Connecting camera
(1) Connect CCTV camera to MD3200M with BNC cable as below.
<Note>
1. The video type for all channels should be either NTSC or PAL, not be combined both.
2. MD3200M sets video signal’s impedance (75Ω ) automatically.
75-Ohm termination register is always connected on video input, and can't be removed. So
MD3200M's video input must be a terminal of the connection.
3. Video Type(NTSC/PAL) should be changed after opeting MD3200M. The order of camera
recognition follows Ch1 camera through Ch32 camera and 1
st
recognized camera type leads other
camera type.
4.2. Connecting monitor
(1) Connect CCTV monitor to MD3200M with BNC cable as shown below;