Filter
Top Products
25
Start a TV demo
1
Press DEMO on the remote control.
2 Press to select a demo and press OK
to view it.
3 Press DEMO to exit.
Reset the TV to factory
settings
You can restore the default picture and sound
settings of your TV. Channel installation settings
remain the same.
1 Press (Home).
2 Press to select [Setup] >
[Installation] > [Factory settings].
3 Press OK or to enter the [Factory
settings] menu.
A factory setting message appears. »
4 Select [Reset] to start resetting.
5 Press (Home) to exit.
• [Teletext 2.5]Enables or disables
Teletext 2.5.
• [E-sticker]For shop mode only. Sets
the location of the e-sticker.
Access decoder channel
You can map channels provided through a
decoder or descrambler to your TV channel
selection. In this way, you can select these
channels by using the RC of your TV. The
decoder or a descrambler must be connected
to EXT1 (SCART).
Set decoder channel
Map channels from a decoder or descrambler
1 Press (Home).
2 Press to select [Setup] >
[Installation] > [Decoder].
3 Press OK or to enter [Decoder] menu
.
4 Press to select [Channel] and press
OK or
to enter.
A list of analogue channels appears on »
the screen.
5 Press to select one channel to map
to the decoder/descrambler channel and
press OK to confirm.
6 Select [Status] and press OK or to
enter.
7 Press to select [EXT 1] (SCART)
the connector used by the decoder/
descrambler.
8 Press OK.
9 Press (Home) to exit.
English
EN