Filter
Top Products
EN-5
Switching the TV on
To switch on the TV, press the POWER
key on the side or top of the set. A blue or
green indicator comes on and after a few
seconds, the screen lights up at the left and
bottom of the front of the set.
If the TV set remains in standby mode
(red indicator), press the - PROGRAM +
key on the side or top controls or the - P
+ key on the remote control.
POWER
PROGRAM
MENU
VOLUME
Using the remote control
Insert the 2 supplied batteries into the re-
mote control. Ensure that the + and - ends
of the batteries are aligned as shown inside
the remote control case.
Warning: The connections do not have
to be made before hanging the TV, but the
cables must be inserted into connectors of
the TV.
Connecting the aerial
Insert the aerial plug firmly into the 75 ohms
aerial socket at the bottom of the TV and in
the wall aerial socket.
Connecting and disconnecting the
mains
Warning: Plasma TV is a Class 1 apparatus.
It must be connected to a mains socket out
with a protective earthing connection.
Warning: Verify that the mains supply volt-
age in your home corresponds to the voltage
printed on the sticker at the rear of the TV.
To connect the TV to the mains, insert the
appliance coupler on the mains cord into the
mains inlet at the back of the TV, and inert
the mains plug into the wall socket.
The appliance coupler of the mains cord on
the TV is the disconnect device.
To disconnect the TV from the mains,
remove the appliance coupler on the mains
cord from the back of the TV or remove the
mains plug from the wall socket. For infor-
mation, see the following illustration.
4 Getting Started