Filter
Top Products
7 Install channels
The first time you setup yourTV, you are prompted to select a menu
language and to install TV and digital radio channels (if available).This
chapter provides instructions on how to reinstall and fine tune channels.
Select your menu language
t Press MENU/EXIT on the remote control and select
[Installation] > [Language].
TV menu
Installation Language
Installation
Channels Autoprogram
Autoprogram
2
3
Press OK to start the installation.
• If you run [Autoprogram] on locked channels, you must to
enteryour PIN code.
• If you have forgotten your PIN, reset it.
Select [Cable] or [Antenna] and press OK.
TV installation
::ii_!!!!!!!!!!!!!!!!!{i!!iii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiill....
_- Select a language and press OK to confirm your choice.
3 Press 41to return to the [Installation] menu.
Set your location to home
You can set the location ofyourTV to home or retail store. Choose
home so that you can change the predefined settings for picture and
sound.
t Press MENU/EXIT on the remote control and select
[installation] > [Preferences] > [Location].
2 Select [Home] and press OK to confirm your choice.
3 Press 4 to return to the [Installation] menu.
Automatically install channels
Before you install channels, ensure that you are registered with your
cableTV provider and that your equipment is correctly connected.
t Press MENU/EXIT on the remote control and select
[Installation] > [Channels] > [Autoprogram] > [Start now].
4
• When [Antenna] is selected, the TV detects antenna signals.
It searches for NTSC and ATSC channels available in your
area.
• When [Cable] is selected, the TV detects signals supplied
by cable. It searches for NTSC, ATSC, and QAN modulated
channels available in your area.
• When complete, this message appears [Channel search
completed.].
Follow the on-screen instructions to complete the installation.
Optimize the signal quality from your
antenna
You can optimize your signal quality by tuning in ATSC channels with
weal< signals, and adjusting the antenna.
t Press MENU/EXIT on the remote control and select
[Installation] > [Channels] > [Installation mode] mode.
2 Select [Antenna] and press 4 to confirm your choice.
3 Press A and I_to enter [Weak channel installation].
4 Highlight a channel from the list of TV channels and press the
green color button on the remote control.
L_ The signal strength for the channel is displayed.
EN 15