Filter
Top Products
5
6
7
Connect the mains jack tx_MAINSat the back of the DVD
Recorder with the power supply using the supplied power cable.
The most important features of the DVD Recorder will appear
on the display.
After the initial installation is completed, this function will be
switched off. How you switch on this function again, read in the
chapter 'User preferences' in the section 'Standby'
Press STANDBY-ON(_on the recorder. '15 T_' n g,L,_r will
appear on the display
Switch on your TV and select the channel used for DVDNCR
playback on your TV Choose between channel 3 or 4.
How do I switch the Recorder between channel 3 and 4?
The factory setting is for channei 3, However, if you would like to
switch to channel 4, proceed as follows:
Hold 4on the remote control while 'fS T_' 0(C' is displayed,
'E0_ ' (channel 4) will appear on the display,
If you want to switch back to channel 3, hold 3. _' (channel 3)
will appear on the display.
After the installation you can switch between the channels only
during standby,
8
Switch your TV to the selected channel (channel 3 or 4), Use
therefore your TV remote control,
The menu for languageselection will appear on the screen.
I x I
I don t see a menu for language selection
¢" Check the cable connections.
¢" Change between channel 3 and 4 on the TV. Problem
This TV channel number must be used in the future for DVD
Recorder playback.
Then, read the paragraph 'Initial installation' in the chapter 'Installing your DVD Recorder'.
Initial Setup
Menu Langua£e
i :
English
Espa_ol
Fran§ais
Press OKto continue
18 Connecting the DVD Recorder