Filter
Top Products
134
PDP Bracket: PDK-5005
Use the Special eye bolt only at the specified locations.
Improper use of Special eye bolts within the Plasma Display main body may
damage the display's blind nut.
Caution
Special eye
bolt
Wire
Wire
PDP bracket
When hanging by wires etc., do not add any devices other than the Plasma Display, PDP
bracket, and the optional speakers nor hang it with a single wire, because there is a danger
that excessive load will be applied, damaging the equipment.
Caution
20˚
Do not attempt to correct tilt by applying downward load with the wires. Doing so may apply
excessive load upon and damage the wire connections and metal mounting fixture.
Caution
During installation, strictly observe the related operating conditions in “3.5 Special installation (PDP-507CMX)
(pg. 35)”.
4.10.5 Wire hanging
Note
When hanging by wires using eyebolts (Plasma Display facing sideways), the display will tilt forward by approximately
20 degrees due to its weight distribution. Therefore, take this into consideration in advance when hanging it by
wires.
Attach wires to the bolts, as indicated in the figure.
To attach the wires to the ceiling, secure two wires at
two independent points for safety.
• To keep the Plasma Display main body from vibrating,
fix the main body by attaching wire to the bottom bolt.
• Use wires strong enough to withstand a weight of
46.4 kg that is the total of the 35.5 kg of the Plasma
Display, the 4.1 kg of the PDP bracket, and the 3.4 kg
x 2 of the optional speakers.
When installing the Plasma Display, do not use the handles as means of hanging the display.
NO!
[507CMX]