Filter
Top Products
178
Menu Mode
STANDARD1, STANDARD2 (STANDARD)*
For an overall bright video, there is no change
(Figure on the left).
For an overall dark video, the peak brightness
is reproduced even brighter (Figure on the
right).
MODE1, MODE2
MODE3
Power consumption is lowered by reducing
the brightness of an overall bight video
(Figure on the left).
Similar to in the STANDARD setting, an overall
dark video is peak brightness is reproduced
even brighter (Figure on the right).
The peak brightness in MODE2 is decreased
by a set amount with respect to that in
MODE1, however it is reproduced brighter
than in MODE3.
Input signal graduation is not controlled but
reproduced accurately. Deterioration of the
panel due to burning is reduced since the
peak brightness of an overall dark video is
not increased.
4) Energy Saving Setting
This is a function that reduces power consumption and reduces deterioration of the panel. This setting controls the
brightness of the screen according to the input signal.
• To make the screen bright and easy to see: Set ‘ENERGY SAVE: STANDARD1, STANDARD2 (STANDARD)*’.
• To perform control according to the brightness of the room and to adjust the screen according to the surroundings:
Set ‘ENERGY SAVE: AUTO’.
• To reduce power consumption: Set ‘ENERGY SAVE: MODE1, MODE2’.
• To reduce deterioration of the panel such as burning: Set ‘ENERGY SAVE: MODE 3’.
• To temporarily turn off the present screen display: Set ‘ENERGY SAVE: MUTE‘ and press the MENU button.
Image mute starts at the same time that the menu disappears.
Factory setting: STANDARD1 (STANDARD)*
Differences in video reproduction by energy saving settings (illustration)
For this kind of input signal
MUTE It temporarily shuts off the screen that is displayed.
To cancel MUTE, press the MENU button, INPUT button etc.
Note
The external sensor changes in stages; from an external light of 200 lux (rough value) to external light of 0 lux.
(As a standard)
When the white window is displayed, the
peak brightness is decreased as shown
below.
• MODE1: Decreased about 50%
• MODE2: Decreased about 60%
• MODE3: Decreased about 75%
AUTO The brightness is automatically changed within the STANDARD (bright) to MODE2 (dark) range according
to the brightness of the room.
* PDP-427CMX