Filter
Top Products
15
S-VIDEO
S-VIDEO
OUT R L
RL RL RLY Pb/Cb Pr/CrIN OUT
BR VD RLHD (H/V SYNC)G(ON SYNC)
INPUT3
INPUT3 INPUT4 INPUT5
VIDEO
INPUT4
INPUT 3/4 ANALOG RGB AUDIO
AUDIO
AUDIO AUDIO AUDIO
COMPONENT
VIDEO
VIDEO
INPUT5
IN
~
^
! @
* (
#
& ) _
%
+
$
COMBINATION
IN OUT
RS-232C
AUDIO AUDIO
INPUT1
AUDIO
OUTPUT INPUT2
ANALOG RGB OUT
(D-Sub)
ANALOG RGB IN
(D-Sub)
INPUT1
DIGITAL RGB
(DVI-D)
INPUT2
2
=-09
13
6 7 845
Connection Panel (PDP-427CMX)
Plasma Display Section
1 COMBINATION IN/OUT
These connectors are used for Plasma Display
setup adjustments.
2 RS-232C
This connector is used for Plasma Display setup
adjustments.
3 AUDIO (OUTPUT) (Stereo mini jack)
Use this port to output the audio of the selected
source component that is connected to the Plasma
Display, to an AV amplifier or similar component.
Note
No sound is produced from the AUDIO (OUTPUT) jack
when the display is OFF or in the Standby mode.
4 AUDIO (INPUT1) (Stereo mini jack)
Use this port to obtain sound when INPUT1 is
selected. Connect this jack to the audio output
connector on the device that is connected to the
plasma panel’s INPUT1.
5 AUDIO (INPUT2) (Stereo mini jack)
Use this port to obtain sound when INPUT2 is
selected. Connect this jack to the audio output
connector on the device connected to the Plasma
Display’s INPUT2.
6 ANALOG RGB OUT (INPUT1) (mini D-sub 15 pin)
Use this connector to output the video signal to an
external monitor or other component.
Note
The video signal is not output from the ANALOG RGB OUT
(INPUT1) connector when the main power of this display is
OFF or in Standby mode.
7 ANALOG RGB IN (INPUT1) (mini D-sub 15 pin)
Use this input to connect components equipped
with RGB outputs jacks such as personal
computers. Verify that the connection corresponds
the signal output format from the connected
component.
8 DIGITAL RGB (INPUT2) (DVI-D jack)
Use this input to connect to a computer.
Connect to an AV component (HDCP supported)
equipped with DVI output connector.
9 SPEAKER (R) terminal
Use this port to connect an external right speaker.
Connect a speaker whose impedance is 6 Ω to 16 Ω.
0 SPEAKER (L) terminal
Use this port to connect an external left speaker.
Connect a speaker whose impedance is 6 Ω to 16 Ω.
When installing PDA-5003
When installing PDA-5004
Controls and Connectors