Filter
Top Products
74
5 Mount the bracket-mounted plasma display onto the
panel support.
1. Hook the bracket hooks onto the bolts protruding
from the left and right of the panel support.
2. Fasten the screw openings under the hooks to
the screw openings on the left and right of the
panel support, using hexagonal socket head bolts
(M8 × 20), as shown.
3. Tighten the hook bolts.
(NOTE 1) This operation must be performed by two or
more persons.
(NOTE 2) In order to ensure safe installation, always
be sure to alternately tighten each bolt two
times or more until they are firmly fixed in
place.
Carriable Stand: PDK-5008
1, 3
1, 3
2
6 Attach the shelf board to the mounting hardware.
Using the providing ornament screws (M6 x 12),
attach the shelf bracket to the stand shelf. Follow
the same procedure to fix the shelf bracket on the
other side to the stand shelf.
7 Mount the shelf board onto the panel support.
Tilt the shelf board, and insert the upper part of the
hook into the panel support slits. Then return it to a
level position.
Panel support
Hook
Slit
[Adjusting the angle of the plasma display screen]
When you want the screen to be easier to see, you
can angle it forwards by altering the bracket attachment
locations. (5°)
0 ° 5 °
To safely attach the brackets to the support columns,
be sure to always have two people set it in place using
the pole as shown in the figure.
Shelf board
Ornament screw
(M6 x 12)
Shelf bracket
8 Adjusting the support caster.
When the mobile cart has been placed into position,
be sure to adjust the support caster to fix into place.
1. Turn the support caster in the direction indicated
by the arrow until the bottom of the caster
touches the floor.
2. Turn the nut at the top of the caster in the
direction indicated by the arrow to fix the caster
into place.
Support caster nut
Bottom of
support caster
Shelf board viewed
from above