Filter
Top Products
Additional information
09
91
En
DVD/CD/Video CD/ player
Problem Remedy
The remote control doesn't
seem to work.
• The
CONTROL IN
jack on the rear panel is connected: Point the
remote control at the connected component to control this player.
• The remote control is too far from the player, or the angle with the
remote sensor is too wide: Use the remote within its operating range
(see
Using the remote control
on page 10).
• The batteries are exhausted: Put in new ones (see
Putting the
batteries in the remote control
on page 10).
No picture/No color.
• Check that the
PURE AUDIO
indicator is not lit. If it is, press the
PURE AUDIO
button (
See also
Front panel
on page 25).
• Incorrect video connections: Check that connections are correct
and that plugs are inserted fully. Also check the video cable for
damage.
• TV/monitor or AV amplifier settings are incorrect: Check the
instruction manual of the connected equipment.
• The video output is set to progressive but your TV/monitor is not
compatible with progressive scan: Press the
PROGRESSIVE
button on
the front panel to set to interlace (the indicator above the button
should not be lit) (see
About progressive scan video
on page 26).
Screen is stretched or
aspect does not change.
• The
TV Screen
setting in the Initial Settings menu is incorrect. See
TV Screen
on page 63 for how to set it correctly for your TV/monitor.
• If your TV/monitor is connected using an S-video cable, try changing
the
S-Video Out
setting (see
S-Video Out
on page 64).
Picture disturbance during
playback or dark.
• This player is compatible with Macro-Vision System copy guard.
Some discs include a copy prevention signal, and when this type of
disc is played back, stripes etc., may appear on some sections of the
picture depending on the TV. This is not a malfunction.
• Due to the player’s copy protection circuits, connection of this
device through a VCR or an AV selector may prevent recording or
cause picture problems. This is not a malfunction.
DV-79AVi.book Page 91 Tuesday,August 2, 2005 4:48 PM