Filter
Top Products
! The center speaker largely determines the
sound image and getting the balance right
isn’t easy. We recommend reproducing a 2-
ch. audio (a CD for example) and getting
the balance right among the speakers ex-
cept for the center, and then reproducing a
5.1-ch. audio (Dolby Digital or DTS) and ad-
justing the center speaker output to the
balance you have already got among the
other speakers.
1 Press AUDIO and hold until AT EQ ap-
pears in the display, then press AUDIO to
select PEQ-2.
# Adjusted PEQ-2 settings are memorized in
CUSTOM 1.
2 Press a or b to select the speaker to be
adjusted.
Each press of a or b selects the speaker in
the following order:
FRT (front speakers)—CENT (center speaker)
—REAR (rear speakers)
# You cannot select speakers whose size is set
at OFF. (Refer to Setting the speaker setting on
page 76.)
3 Press d and then press a or b to select
the equalizer band to be adjusted.
Each press of a or b selects equalizer bands
in the following order:
LOW (low)—MID (mid)—HI (high)
4 Press d and then press a or b to select
the center frequency of selected band.
Each press of a or b selects the frequency in
the following order:
40—50—63—80—100—125—160—200—
250—315—400—500—630—800—1k—
1.25k—1.6k—2k—2.5k—3.15k—4k—5k—
6.3k—8k—10k—12.5k (Hz)
5 Press d and then press a or b to adjust
the equalizer level.
Each press of a or b increases or decreases
the equalizer level. +6 to –6 is displayed as the
level is increased or decreased.
6 Press d and then press a or b to select
the desired Q factor.
Each press a or b switches between the fol-
lowing Q factor:
WID (wide)—NAR (narrow)
# You can adjust parameters for each band of
the other speakers in the same way.
7 Press BAND to return to the playback
display.
Note
You can select a center frequency for each band.
You can change the center frequency in 1/3-oc-
tave steps, but you cannot select frequencies that
have intervals shorter than 1 octave among the
center frequencies of the three bands.
Available accessories
En
80
Section
04