Filter
Top Products
Message Cause Action
PROTECT All the fileson the inserted disc are
secured by digitalrights manage-
ment (DRM)
Replace disc.
Error messages on the display
Message Cause Action
ERROR-02-XX Dirty disc Clean disc.
Scratched disc Check that thedisc is loadedcorrectly.
The disc isloaded upside down Check that thedisc is loadedcorrectly.
THERMAL PROTECTION IN
MOTION
The temperature ofthis unit is out-
side the normaloperating range
Wait until theunit’s temperature returns to
within normal operatinglimits.
DIFFERENT REGION DISC The disc does nothave the same re-
gion number as this unit
Replace the DVD videowith one bearing the
correct region number.
NON-PLAYABLE DISC This type of disc cannot beplayed
by this unit
Replace the disc withone this unit can play.
PROTECTED DISC All the fileson the inserted disc are
secured by digitalrights manage-
ment (DRM)
Replace disc.
Understanding auto TA and EQ error messages
When correct measurement of car interior acoustic characteristics is not possible using the auto
TA and EQ, an error message may appear on the display. If an error message appears, refer to the
table below to see what the problem is and the suggested method of correcting the problem. After
checking, try again.
Message Cause Action
ERR_MIC Microphoneis not connected. Plug the supplied microphone securelyinto
the jack.
ERR_FSP, ERR_FLSP, ERR_FRSP,
ERR_CSP, ERR_RSP,ERR_RLSP,
ERR_RRSP, ERR_SW
The microphone cannotpick up the
measuring tone ofa speaker.
! Confirm thatthe speakers are connected
correctly.
! Correct the input level settingof the power
amp connected tothe speakers.
! Setthe microphone correctly.
ERR_NOIS The surrounding noiselevel is too
high.
! Stop yourcar in aplace that is asquiet as
possible, and switchoff the engine, air condi-
tioner or heater.
! Setthe microphone correctly.
Additional Information
En
84
Appendix