Filter
Top Products
Troubles hooting
Common
Symptom Cause Action (See)
Power doesn’tturn on.
The unit doesn’t operate.
Leads and connectors are incor-
rectly connected.
Confirm once more that allconnections are
correct.
The fuse is blown. Rectify the reasonfor the fuse blowing, then
replace the fuse.Be very sure to installthe
correct fuse with the same rating.
Noise and other factors are causing
the built-in microprocessorto oper-
ate incorrectly.
Turn the unitoff and thenon.
Operation with the remote con-
trol isn’t possible.
The unit doesnot operate cor-
rectly even whenthe appropriate
remote control buttonsare
pressed.
The remote controloperation mode
is incorrect.
Switch to the correct remote control mode.
(Page 13)
Battery power is low. Load new battery. (Page 8)
Some operations areprohibited
with certain discs.
Check by usinganother disc.
Playback is notpossible. The discis dirty. Clean disc. (Page 86)
The loaded disc is a typethis unit
cannot play.
Check what typethe disc is.
Non compatible videosystem disc
is loaded.
Change to adisc compatible toyour video
system.
No sounds areheard.
The volume levelwill not rise.
Cables are notconnected correctly. Connectthe cables correctly.
The unit is performing still, slowmo-
tion or frame-by-frame playback.
There is nosound during still, slowmotion or
frame-by-frame playback.
The icon
is displayed, andop-
eration is notpossible.
The operation is prohibited for the
disc.
This operation isnot possible.
The operation is not compatible
with the disc’s organization.
This operation isnot possible.
The picture stops(pauses) and
the unit cannotbe operated.
Reading of datahas become impos-
sible during playback.
After stopping playbackonce, start playback
once more.
There is nosound.
Volume level islow.
The volume levelis low. Adjust the volumelevel.
The attenuator ison. Turn the attenuator off.
There is audioand video skip-
ping.
The unit is not firmly secured. Secure the unitfirmly.
The picture isstretched, the as-
pect is incorrect.
The aspect settingis incorrect for
the display.
Select theappropriate settingfor yourdisplay.
(Page 48)
When the ignitionswitch is
turned ON (orturned to ACC),
the motor sounds.
The unit is confirming whether a
disc is loadedor not.
This is anormal operation.
Additional Information
En
81
Appendix
Additional Information