Filter
Top Products
Connecting up
02
12
En
Connecting to a cable box or satellite receiver (1)
If you are using a cable box or satellite receiver with only a few scrambled channels, follow the setup on this page. If
many or all the channels are scrambled, we recommend using the setup on the following page.
Using the setup on this page you can:
• Record unscrambled channels by selecting them on this recorder.
• Record scrambled channels by selecting them on the cable box/satellite tuner.
• Watch one channel while recording another.
Important
• Do not connect this recorder ‘through’ your VCR, satellite receiver or cable box. Always connect each component
directly to your TV or AV amp/receiver.
1 Connect RF antenna cables as shown.
This enables you to watch and record TV channels.
2 Connect the AUDIO and VIDEO OUTPUT jacks on
this recorder to a set of audio/video inputs on your
TV using a set of A/V cables (as supplied).
This enables you to watch the output from this recorder.
3 Connect the audio/video output of your cable
box/satellite tuner to the INPUT 1 jacks on this
recorder using a set of A/V cables.
This enables you to record scrambled TV channels.
Note
The diagram shows standard video connections, but
you can alternatively use the S-video or component
video connections if they’re available.
AC IN
IN
OUT
RL
AUDIO
VIDEO
S-VIDEO
S-VIDEO
RL
AUDIO
OUTPUT INPUT 1
DIGITAL
OUT
ANTENNA
Y
P
B
P
R
VIDEO OUT
COMPONENT VIDEO OUT
Cable box/
Satellite receiver
VHF/UHF
IN
VHF/UHF
OUT
VHF/UHF
IN
A/V
OUT
A/V
IN 1
1
1
2
3
TV
Antenna/cable TV
wall outlet
1
DVR-230_YP.book Page 12 Monday, July 4,2005 5:20 PM