Filter
Top Products
The Initial Setup menu
08
49
En
There are three different recorder IDs. When set to
Recorder2
or
Recorder3
, the remote control mode is
shown in the front panel display.
After selecting a new recorder ID, you have to confirm the
change by selecting
Yes
or
No
(use the
/
buttons),
then pressing
ENTER
.
Note that as soon as you change the recorder ID, the
remote becomes inoperative until you change the remote
to the same ID.
To set the remote, press and hold
RETURN
and a number
button (
1
,
2
or
3
) for five seconds.
Setup Navigator
• Default setting:
n/a
The Setup Navigator appears automatically when you
switch on the recorder for the first time (or after resetting
the recorder). It is also available from the Initial Settings
menu should you need it at any other time.
See also
Switching on and setting up
on page 18.
Power Save
• Default setting:
Off
When set to
Off
, signals arriving at the
ANTENNA IN
terminal are passed through to the
ANTENNA OUT
terminal when the recorder is in standby.
•
On
– No through function for the antenna terminal
•
Off
– Through function for the antenna terminal
Remote Control
Recorder1Remote Control
Remote Control
Recorder2
Remote Control
After changing this setting, the remote
control mode must be changed.
OK to Continue ?
NoYes
Basic
Disc
Video
Audio
Recording
Playback
Clock
Tuner
OSD Language
Clock
Tuner
OSD Language
Display
Remote Control
Power Save
Basic
Setup Navigator
Basic
Disc
Video
Audio
Recording
Playback
Clock
Tuner
OSD Language
Display
Remote Control
Basic
Setup Navigator
Power Save
Power Save
Power Save
Off
DVR-230_YP.book Page 49 Monday, July 4,2005 5:20 PM