Filter
Top Products
The Initial Setup menu
14
102
En
AV1 Out Video • Sets the AV1(RGB)-TV SCART output to standard composite video
(compatible with all TVs).
S-Video Sets the AV1(RGB)-TV SCART output to S-video. Recommended if you
are using a long SCART cable.
RGB Sets the AV1(RGB)-TV SCART output to RGB. Good quality but check
your TV for compatibility.
If you choose a setting that is incompatible with your TV you may not be able to see any picture at all. In this case either switch off and reconnect
using the supplied video cable, or reset the recorder (see Resetting the recorder on page 109).
The Component Video Out setting (see page 101) has no effect when AV1 Out is set to RGB.
AV2/L1 In Video • Sets the AV2 (INPUT 1/DECODER) SCART input to standard compos-
ite video.
S-Video Sets the AV2 (INPUT 1/DECODER) SCART input to S-video.
RGB Sets the AV2 (INPUT 1/DECODER) SCART input to RGB.
Decoder Use this setting if you connected a decoder to the AV2 (INPUT 1/
DECODER) SCART connector. For scrambled channels, make sure that
the channel Decoder setting is set to On. (See Manual CH Setting
page 101.)
NTSC on PAL TV On • NTSC discs will play correctly on PAL-only TVs.
Off Use if your TV is already NTSC-compatible.
Many recent PAL TVs are compatible with NTSC input and so this setting can be switched off. Check the operating instructions that came with
your TV. See also About NTSC on PAL TV on page 107 for related information.
Audio In Settings
Nicam Select NICAM • Record the NICAM audio in a NICAM broadcast.
Regular Audio Record the non-NICAM audio in a NICAM broadcast. (You can still
switch the audio to record using the AUDIO button before recording.)
Tuner Level Normal • Standard setting.
Compression Use if the audio level from the built-in tuner is excessive, causing dis-
tortion.
External Audio Stereo • Select if the audio from the currently selected external input is stan-
dard stereo.
Bilingual Select if each channel carries a separate soundtrack.
When the external audio is from the DV input, an audio subcode channel within the DV audio tells the recorder whether the audio is stereo or
bilingual. This has priority over the setting you make here.
Bilingual Recording A/L • Record the left (A) channel of a bilingual source when recording to
HDD with HDD Recording Format set to Video Mode ON, to DVD in
Video mode or in LPCM mode, from an external source.
B/R As above, but for right (B) channel recording.
When recording bilingual audio to DVD in VR mode (except in LPCM mode), or to HDD with HDD Recording Format set to Video Mode Off (except
in LPCM mode), both audio channels are recorded and you can switch to the one you want on playback.
Setting Options Explanation
13 Initial_Settings.fm 102 ページ ２００５年２月１４日 月曜日 午後７時１１分