Filter
Top Products
Connections
17
En
02
1 Connect the VIDEO OUTPUT jack to a
video input on your TV.
Use the yellow jack of the supplied audio/
video cable for the video connection.
2 Connect the AUDIO OUTPUT jacks to
the corresponding audio inputs on your TV.
Use the red and white jacks of the supplied
audio/video cable for the audio connection.
Make sure you match up the left and right
outputs with their corresponding inputs for
correct stereo sound.
Using the S-video or component
video output
1 Connect the S-video or component
video output to a similar input on your
TV.
For an S-video connection, use an S-video
cable (not supplied) to connect the
S-VIDEO
OUTPUT
jack to an S-video input on your TV.
For a component video connection, use a
component video cable (not supplied) to
connect the
COMPONENT VIDEO OUT
jacks to a component video input on your TV.
See also
Component Video Out
on page 126
for how to set up the component video
output for use with a progressive scan-
compatible TV.
2 Connect the AUDIO OUTPUT jacks to
the corresponding audio inputs on your
TV.
You can use the supplied audio/video cable,
leaving the yellow video plug disconnected.
Make sure you match up the left and right
outputs with their corresponding inputs for
correct stereo sound.
Connecting to a cable box or
satellite receiver
If you have a cable box or satellite receiver
with a built-in decoder, connect it to this
recorder and your TV as shown on this
page.
1
If you are using a separate decoder
box for your cable/satellite TV, set up
following the instructions on the next page.
Using the setup on this page you can:
• Record any channel by selecting it on
the cable box, satellite receiver or digital
terrestrial receiver.
• Change channels and set timer
recordings on the external receiver using
the GUIDE Plus+® system (via the
G-LINK™ cable, and after setting up).
Important
• Do not connect this recorder to your TV
‘through’ your VCR, satellite receiver or
other component. Always connect each
component directly to your TV or AV
amplifier/receiver.
• When using the GUIDE Plus+ system to
make a timer recording from an external
receiver, make sure that the external
receiver is switched on.
TV
AC IN
DIGITAL
AUDIO OUT
COAXIAL
HDMI OUT
CONTROL
G-LINK
IN
AV 1 (RGB) – TV
AV 2 (INPUT 1/DECODER)
S-VIDEO
VIDEOAUDIO
L
R
INPUT 3
COMPONENT VIDEO OUT
Y
P
B
P
R
ANTENNA
IN
OUT
ANTENNA(DIGITAL)
IN
OUT
5 V
30 mA
OUTPUT
1
2
COMPONENT
VIDEO OUT
S-VIDEO
OUTPUT
AUDIO
OUTPUT
To audio input
To component video input
To video input
Note
1 The diagram shows SCART video connections, but you can alternatively use any of the other audio/video
connections.
DVR550HXS_WV_EN.book 17 ページ ２００７年３月３０日 金曜日 午前１０時４８分