Filter
Top Products
Recording
05
43
En
• If the HDD is being used for playback or high-speed
copying when an Auto Replace Recording is due to
start, the new timer recording will not replace the old
one. However, the next time the timer recording
starts, both of the older two programs will be erased.
Editing a timer program
You can change any of the settings in a timer program
before the recording is due to start.
1 Press TIMER REC.
2 Highlight the timer program you want to
change
..
..
3 Press
then select ‘Modify’ from the command
menu panel.
Alternatively, press
ENTER
.
The Timer Program Set screen appears from which you
can edit the settings.
4 Edit the timer recording settings as necessary.
5 Select ‘Store Program’ to finish.
Confirm the settings you made from the following screen.
Deleting a timer program
You can delete timer programs you no longer need.
1 Press TIMER REC.
2 Highlight the timer program you want to erase
..
..
3 Press
then select ‘Erase’ from the command
menu panel.
• Select
Yes
to confirm or
No
to cancel.
• You can also just press
CLEAR
when the timer
program is highlighted.
Skipping a regular timer program
If you’ve set a regular daily or weekly timer program, you
can set the recorder to skip the next scheduled
recording.
1 Press TIMER REC.
2 Highlight the timer program you want to skip
..
..
3 Press
then select ‘Cancel Once’ from the
command menu panel.
• In the timer program list,
Cancel Once
appears by
the program.
• You can also just press
when the timer program is
highlighted.
Extending a timer recording in progress
You can extend a timer recording beyond the
programmed end time in two different ways. This can be
useful if a broadcast program overruns, for example.
Moving the end time by 30-minute blocks
1 During timer recording, press and hold
ì
REC for
three seconds.
The timer indicator disappears from the front panel
display.
2 Press
ì
REC repeatedly to extend recording in 30
minute increments.
Programming a new end time
You can edit the end time of a timer recording you have
previously set.
1 Press TIMER REC.
2 Highlight the timer program you want to
change.
3 Press
then select ‘Modify’ from the command
menu panel.
Alternatively, press
ENTER
.
The Timer Program Set screen appears from which you
can edit the settings.
4 Edit the end time as necessary.
You can also edit the
Extend
time parameter.
5 Select ‘Store Program’ then press ENTER.
6 To exit the timer recording screen, press HOME
MENU.
HOME
MENU
ENTER
PREV NEXT
TIMER REC
DVR630HS_RL.book 43 ページ ２００５年３月１８日 金曜日 午前９時４９分