Filter
Top Products
Programming the Polaroid Universal Remote Control
Following are two sets of instructions for programming your Polaroid Universal Remote
Control to work with other devices in addition to your Polaroid TV. (If you only wish to use
the remote control with your Polaroid TV, no additional programming is necessary.)
Begin with the Direct Programming Setup, and if unsuccessful, go on to the Auto Code
Search Setup.
Direct Programming Setup
This method requires use of one of the device codes found in the Device Code Table
(see last paqes of your Operatinq Manual). Begin with the first code listed for your device.
1 Turn the device power off and point the Polaroid Universal Remote Control at the device
you wish to control.
2 Momentarily press a device button on the Polaroid Universal Remote Control (TV, DVD,
CBL, or AUX). When you release the device button the red LED at the top of the remote will
blink once.
Note: For devices other than a TV, DVD, or Cable Box, use the AUX key.
3 Press and hold the SET button (top-left button) until you see the LED blink once, followed
by two short blinks. Release the SET button after you see the two short LED blinks.
4 Enter the 5-digit code from the code table for the device you want to control. The LED
blinks once each time you press a numbered button. After you enter the last digit:
a) If the code you entered is the correct code for your device, you will see the LED blink
twice. Go to step 5.
b) If the code you entered is not the correct code for your device, you will see the LED
blink once. Repeat steps 2-4, this time choosing the next code in the list.
5 Press the Power button (top right-side button) on the remote and your device power
should turn on. If the power does not turn on, repeat the entire procedure beginning with
step 1.
If you are unable to program the remote properly after two or more attempts using the Direct
Programming Setup, go on to the Auto Code Search Setup.
42