Filter
Top Products
Administrator’s Guide for the V500 System
5 - 2 www.polycom.com/videodocumentation
Using the V500 Web Interface
You can use the V500 web interface to perform most of the calling and
configuration tasks you can perform on the local system.
Accessing the V500 Web Interface
To configure your browser to use the V500 web interface:
1. Be sure that you use Microsoft Internet Explorer 6.0 or later as your web
browser.
2. Configure these settings:
• Allow cookies: Enabled
• Force pages to reload on every visit to a page: Enabled
To access the system using the V500 web interface:
1. On a PC, open a web browser.
2. In the browser address line, enter the system’s IP address (for example,
http://255.255.255.255) to go to the V500 web interface.
3. Enter admin as the user name, and the password, if a password has been
established.
You can use the V500 web interface to configure all of the system settings except the remote
management settings. For security reasons, these settings must be configured on the local
system by an administrator.