Filter
Top Products
Preparing for Installation
16 Chapter 1
Attaching the LNB Support Arm and
Adapter
1. Attach the rectangular LNB feeder tube to the antenna socket making sure that the
round hole for the spacer is positioned as shown in the diagram below. Tighten
the bolt while holding the nut.
LNB
#8 x 1” Phillips Head Screw
(LNB & Adapter Mounting)
.81 Long Spacer
(Feed Tube Mounting)
1/4” Flat Washer
1/4” x 1-1/2” Hex Head Bolt
(Feed Tube Mounting)
1/4” Hex Flange Nut
#8 Insert Nut
(LNB & Adapter Mounting)
Feeder tube
LNB adapter
2. Attach the LNB adapter to the feeder tube and secure it by using a #8 hex insert and a
1” long phillips head screw.
Move On to the Next Section
Now that you have all of the preliminary installation steps completed, go on to the next
section “Mounting the Mast.”