Filter
Top Products
Chapter 3 29
Final Installation
Leveling Front-to-Back
1. Loosen the two bolts securing the mast to the mounting foot so the mast moves
freely.
2. Place a bubble level on the mast as shown in the figure. Move the mast so the
bubble is centered in the level’s window.
Rotate mast as
needed
Rotate mast as
needed
Level
Not Level
Level
Not Level
3. Tighten the two bolts securing the mast to the mounting foot.
Final DIRECTV PLUS™ Dish Assembly
1. Attach the reflector to the support arm:
The top of the mast should slip on easily into the antenna clamp. Make sure that
the top of the mast has reached the pivot bolt running through the top of the
antenna clamp collar. The antenna should move from side to side easily once it is
on top of the support arm (Make sure that the mounting foot assembly is tightened
before setting the antenna on top).