Connections & Setup
8 Chapter 1
Explanation of Jacks and Cables
The diagrams below illustrate jacks found on the back of the TV. When
connecting cables, be sure to connect corresponding outputs and inputs (video
input into video out, right audio input into right audio out, etc.).
This section describes the jacks and cables you might use to make connections
(cables may be ordered separately by calling the number on page 65). There are
several ways to connect components to your TV.
Different jacks and cables provide a different level of performance. It’s
important to remember the different degrees of picture quality for comparison.
The HDMI/DVI and component jacks are considered excellent; S-Video is very
good; composite jacks are good, while connecting components to the Antenna
or Cable input is fair.
EXTERNAL
AMP MAX
POWER
RATING!
(60 WATTS
into
8 OHMS)
CENTER
SPEAKER
INPUT
FIXED/
VARIABLE
AUDIO
OUTPUTS
SUBWOOFER
CTR
R
REAR
L
REAR
MATRIX
SURROUND
OUTPUTS
R
L
INPUT 1
L
R
S-VIDEO
V
FIXED/
VARIABLE
AUDIO
OUTPUTS
CABLE
INPUT
ETHERNET
For Factory Use Only
TV
DIGITAL
AUDIO
OUTPUT
AUDIO/
VIDEO
OUTPUT
V
R
L
EXTERNAL
AMP MAX
POWER
RATING!
(60 WATTS
into
8 OHMS)
CENTER
SPEAKER
INPUT
SUBWOOFER
CTR
R
REAR
L
REAR
MATRIX
SURROUND
OUTPUTS
R
L
WIRED
IR
CableCARD™
L
R
S-VIDEO
V
INPUT 3
COMPOSITE
INPUTS
INPUT 2
ANTENNA
INPUT
COMPONENT/
COMPOSITE
INPUTS
Use menu for
composite
video.
L
R
P
R
P
B
Y/VIDEO
INPUT 4
L
R
P
R
P
B
Y/VIDEO
HDMI/DVI
INPUT
Use menu for
DVI audio.
POWER
(AC 120V~60Hz)
SPEAKERS
• CENTER SPEAKER INPUT To use the TV’s internal speakers as the center
speaker, connect the audio/video receiver’s center channel output to the
TV’s center channel input.
Note: Go to Center Speaker In in the Audio Connections menu to
choose the option The center channel output from an audio receiver.
AUDIO/VIDEO OUTPUTS
FIXED/VARIABLE AUDIO OUTPUTS
• CENTER Provides center surround sound to an A/V receiver or audio
amplifier.
• R and L REAR Provides right and left rear surround sound.
Note: To turn the TV’s internal speakers on and off, press MENU on the
remote control and choose Audio, then Audio Connections. Then choose
Fixed/Variable Out from the menu and choose an option.
• SUBWOOFER Provides lower bass frequencies out from the TV to a
powered subwoofer or audio receiver with a subwoofer jack.
Note: Go to Fixed/Variable Output in the Audio Connections menu to
set option to Yes if an external subwoofer is being used.
• R and L Provides right front and right rear mixed sound, and left front
and left rear mixed sound.
16339350.01 Connections 6/11/04, 6:03 PM8