Filter
Top Products
Chapter 2 23
Using the Remote Control
INPUT Toggles through the TV’s available input sources (INPUT 1, INPUT 2,
INPUT 3, INPUT 4, Front Input, HDMI/DVI, and last-active channel). To quickly
access an input, press the INPUT button and the input number, for example,
INPUT +1 to access INPUT 1.
MENU Makes Main Menu appear and disappear.
MUTE Reduces the TV’s volume to its minimum level. Press again to restore
volume. The TV Audio Output menu must be set to Variable Level, Speakers On
to control the TV’s volume.
OK When a menu item is highlighted, press OK to select the item.
ON•OFF Turns the TV on or off. In other modes (DVD or AUX), and if
programmed, turns the component on and off.
PIP Makes the PIP window appear and disappear (See Chapter 3 for more
information about using PIP).
REVERSE, PLAY, FORWARD, RECORD, STOP, PAUSE If programmed,
provides transport control for some remote-controllable VCRs and CD and DVD
players.
SKIP Press once before changing channels and the TV returns to the original
channel after 30 seconds. Press repeatedly to add more time. Press CLEAR to
cancel.
SWAP When using PIP, switches the main picture with the PIP window.
TV Places the remote in TV mode. Turns on the TV and tunes to the last-
viewed TV channel or input.
VOL – or VOL + Decreases or increases the TV’s volume. The TV Audio
Output menu must be set to Variable Level, Speakers On to control the TV’s
volume.
Programming the Remote to Operate
Other Components
The universal remote can be programmed to operate many brands of remote-
controllable VCRs, audio components, DVD players, cable boxes, satellite
receivers and other components. In addition to being programmed to operate
your television, it’s already programmed to operate most RCA, GE, and Proscan
components.
The AUX button can be programmed to operate most brands of an additional
remote-controllable component: satellite receiver, cable box, DVD, VCR, and an
audio component. A second and third RCA TV can be programmed to any
component button, except the TV button. Go to page 54 for more information
on programming the remote to another TV.
Note: The TV button can’t be programmed on this remote to control any
component; it controls only this TV.
Tip
To turn off most RCA, GE, and Proscan
components that are connected to the TV, press
ON•OFF twice within two seconds and hold
remote steady until indicator turns off.
DVD
ON OFF
AUX
CLEAR
123
4
56
7
89
0
REVERSE
PLAY
STOP
Tip
By default, the AUX button is programmed for
an RCA VCR (VCR2). If auto tuning is set up, it
will tune to VCR2 input channel.
You’ll use these buttons when you
program the remote for other
components.
Important Note: The remote
may not be compatible with all
models of all brands of
components. It also may not
operate all functions of your
component.
16339350.02 Remote 6/11/04, 6:03 PM23