Filter
Top Products
Chapter 1 3
Graphics contained within this publication are for representation only.
Chapter 1: Connections and Setup
Things to Consider Before You Connect
Protect Against Power Surges
• Connect all devices before you plug any of their power cords into the wall outlet or power strip. NEVER plug your
TV into an outlet that is controlled by a wall switch.
• Turn off the TV and/or device(s) before you connect or disconnect any cables.
• Make sure all antennas and cables are properly grounded. Refer to the Important Safety Instructions at the
beginning of the manual.
Protect Devices from Overheating
• Don’t block ventilation holes on any of the components. Arrange the devices so that air can circulate freely.
• Don’t stack devices.
• If you place devices in a stand, make sure you allow adequate ventilation.
• If you connect an audio receiver or amplifi er, place it on the top shelf so the heated air from it won’t fl ow around
other devices.
Position Cables Properly to Avoid Audio Interference
Insert each cable fi rmly into the designated jack.
Use Indirect Light
Don’t place the TV where sunlight or room lighting will be directed toward the screen. Use soft or indirect lighting.
Connection Illustrations
The devices used in the connection illustrations are for representation only. The input jacks and the output jacks on the
back of your devices (VCR, DVD player, etc.,) might look different than those illustrated.
Check Supplied Parts
Check that the following parts were packed with your product.
Remote control 2 AA batteries
Power cord
123
456
789
ON•OFF
CH+
CH-
INPUT MUTE
GO BACK
VOL+
VOL-
OK
CLEAR MENU
PRESETS CC INFO FORMAT
SLEEP CALENDAR SOUND PC INPUT
Wall mount plate
TV’s base, along with
8 screws to attach the
base to TV
1652880A.indb 31652880A.indb 3 8/22/05 4:15:44 PM8/22/05 4:15:44 PM