Filter
Top Products
24 Chapter 2
Using the Remote Control
Using Manual Code Search
Note: Before using manual code search, you must use Direct Entry first. This lets the remote know
which type of device to begin searching codes. Then proceed with the following steps.
1. Turn on the device you want to control.
2. On your remote control, simultaneously press and hold the ON•OFF and MUTE buttons (approximately
3 seconds) until a device button remains lit. Then release the buttons.
3. Press and release the device button (SAT•AUX, DVD) you want to program.
4. Repeatedly press and release the ON•OFF button, watching for the device to respond. If it does turn
off, press and release the OK button within 3 seconds to save the code. If you accidentally passed the
code before saving it, press the left arrow button to backtrack through the codes; then use the right
arrow button to go forward through the codes again.
When all codes have been searched, the device button flashes 3 times, then the remote exits manual code
search and returns to normal operation.
Using Automatic Code Search
1. Turn on the device you want to control.
2. On your remote control, simultaneously press and hold ON•OFF and MUTE (approximately 3 seconds)
until a device button remains lit. Then release the buttons.
3. Press and release the device button you want to program.
4. Press and release the ON•OFF button once. There is a delay of approximately 6 seconds before the
remote starts the code search.
The device buttons blinks each time the remote control sends a code to test with your device. Keep
pointing the remote at the device.
5. Once the device turns off, quickly press the OK button to save the code. If you accidentally passed the
code before saving it, press the left arrow button to backtrack through the codes; then use the right
arrow button to go forward through the codes again.
When all codes have been searched, the device button flashes 3 times, then the remote exits automatic code
search and returns to normal operation.
How to Use the Remote After You’ve Programmed It
Once the remote has been programmed successfully, you are ready to use it to operate your devices.
To Operate the Device:
• Press the appropriate device button (SAT•AUX, DVD) to set the remote to control the device, for
example, press DVD to control your DVD player.
• Press ON•OFF to turn the device ON or OFF.
• Use the remote buttons that apply to that device.
Note: The remote control may not be compatible with all brands and models of devices.
Modes of Operation
The button corresponding to the mode the remote is in lights up when you press any button that works in
that mode. For example, if you’re in TV mode and you press the VOL+ button, the TV button lights up. This
tells you that the command to increase the volume is being sent to the TV (and not the satellite receiver, for
example).