RCA pmn Satellite TV System User Manual


 
Reference
63
Programming the Remote to Control
Other Devices
The AUX button is a device button that can be programmed to
control a second VCR, a cable box, or a laserdisc player.
1. Turn on the device to be programmed.
2. Look up your brand and its code number on code list on the
following pages.
3. Press and hold the AUX button.
4. Enter the three-digit code from the code list.
6. Release the AUX button and press POWER or CHAN UP/DOWN
to see if the device responds to the remote commands.
7. Repeat these steps using the next code listed for your brand
until the device responds to the remote commands.
Using the Remote Buttons to Control a
Device
Once the remote has been programmed with the correct codes,
you are ready to use it to control your devices.
To operate the device:
1. Press the device button (TV, DSS1, DSS2, VCR, or AUX) to set
the remote to control the device.
2. Press POWER to turn the device off or on.
3. Use the remote buttons that apply to that device.
After you program the remote to
control a device, record your AUX
code here for easy reference.
This remote may not operate all
models of the brands that are
shown. Use the codes shown in
this manual, or on the sheet
packed with your remote.