Filter
Top Products
Setting Up the VCR
6. Place channels in the VCR’s memory.
Channels 2 through 13 including line input (L1/L2) are in the
VCR’s memory when you first turn it on. Pressing CHANNEL up
or down stops on these channels. To get additional channels
available on your antenna or cable system, you must use the Auto-
Search Channels feature of the VCR. If you ever change cable or
antenna signals, you may need to Auto-Search Channels again.
A. Press VCR1 to set remote to control VCR.
B. Press MENU•PROG on the remote to see the VCR MAIN MENU
on the TV screen. If the menu does not appear on the TV
screen:
• Make sure TV is tuned to same channel as CH3 CH4
switch on VCR or the TV’s video input (refer to TV’s
manual).
• Press VCR1 and then press MENU•PROG.
• If you use a basic hookup, check VCR indicator in display
panel — it should be on. Press TV•VCR to turn it on.
• Check the connections.
C. Press 4 to select CHANNEL SETUP.
D. Press 1 to begin Auto-Search Channels.
Wait until the channel numbers stop changing. This takes
about one to two minutes. The TV will then tune to the lowest
channel found. Pressing CHANNEL up or down will select
only the active channels.
The VCR automatically selects ANTENNA or CABLE of the
Tuning Mode feature in the CHANNEL SETUP menu. If you
need to change the setting manually, press 3.
7. Add or remove channels from the VCR’s memory.
You may want to add or remove channels if some of the channels
are not active, have weak signals, or you do not want to watch
them.
A. Press VCR1.
B. Press MENU•PROG on the remote to see the VCR MAIN MENU
on the TV screen.
C. Press 4 to select the CHANNEL SETUP menu.
D. Press 2 to select the ADD/REMOVE CHANNEL menu.
E. Follow the directions on the screen.
F. Add or remove more channels by entering channel numbers or
using CHANNEL up or down.
VCR MAIN MENU
1 VCR Plus+ Programming
2 Timer Programming
3 Review Programs
4 Channel Setup
1 VCR Plus+ Programming
CHANNEL SETUP
1 Auto-Search Channels
1 Auto-Search Channels
VCR MAIN MENU
1 VCR Plus+ Programming
2 Timer Programming
3 Review Programs
4 Channel Setup
1 VCR Plus+ Programming
Startup
9
CH 14
Searching Channels
CHANNEL SETUP
1 Auto-Search Channels
1 Auto-Search Channels
CHANNEL SETUP
1 Auto-Search Channels
2 Add/Remove Channels
2 Add/Remove Channels
ADD/REMOVE CHANNEL
CH 03
is presently ADDED
Press CLEAR to remove
Press MENU to exit