Filter
Top Products
25
Using the Remote Control
Controlling an Auxiliary RCA Component
The remote that came packed with your VCR is also capable of controlling one compatible
RCA component, such as an AM/FM radio, CD player, tape players, phonograph, RCA
digital satellite receiver, or RCA DVD component. The remote must be programmed for the
specific component it is to control. To program the remote, use the code that corresponds to
your component.
Program the Remote for an Auxiliary Component
1. Turn on the component.
2. Point the VCRÕs remote at the component.
3. Hold the AUX button and press three number buttons to
enter the code for your component.
4. Release the buttons.
5. Press PWR on the remote. If the component turns off,
setup is complete.
Operate the Auxiliary Component
After you have setup your remote to control your component, test the
buttons to see which ones operate the component.
1. Point the remote at the component and press AUX.
2. If the component does not turn on in step 1, press AUX and then
PWR.
3. Test the buttons on the remote to see which ones operate your
component. Refer to the ÒRemote ControlÓ section.
*The remote may not be able to control every RCA model of auxiliary equipment listed.
Type of RCA Auxiliary Equipment and Code
Cassette Cassette
RCA AM/FM AUX Phono Tape1 CD DSS Tape2 DVD
003 004 005 006 007 008 009 010