Filter
Top Products
Operation
78 D-73d Series Installation/Operation Manual
PRE
L
IMINAR
Y
•Choose Frame Packing to have the 3Dimension Processor decode frame packed
data into left and right eye data. In this mode, the DHD Controllers do not perform any
3D processing.
Reverse Eyes: By default, the Primary and Secondary DHD Controllers are dedicated to
“left eye” and “right eye” image processing respectively. To reverse this relationship,
choose Reverse Eyes from the 3D Processing menu and set it to On.
Sleep Timer Select Sleep Timer from the Main Menu to turn off the D-73d after a specified interval.
Press or to select Off, 30 Minutes, 60 Minutes, 90 Minutes, 2 Hours or 4 Hours.
Then, press ENTER.
Information Signal / System: Select Information from the Main Menu, then choose either Signal or
System to display information about the current input signal (resolution, frequency, type et
cetera) and installed firmware versions, as well as other information that uniquely identifies
your DHD Controller and display device.
Should you ever need to contact Runco Technical Support, this information will help them
answer your questions or resolve product performance issues.
Network: Select Information from the Main Menu, then choose Network to display
information about the Ethernet network connection.
To enable network communication via Ethernet, refer to IP Configuration on page 88.
Field Service / Manufacturing: The Field Service and Manufacturing menus are
password-protected and intended for use only by Runco service personnel and factory
technicians.
Sleep Timer
Î
Off
30 Minutes
60 Minutes
90 Minutes
2Hours
4Hours
➤
Information
Signal
System
Network
Field Service
Manufacturing
➤
Signal
Input Source HDMI 1
Signal Format 1080p/60
Input Resolution 1920x1080
Vertical Freq 59.94 Hz
Horizontal Freq 67.500 kHz
Pixel Clock 148.500 MHz
Color Space REC709
Sync Type Separate
3D Mode Auto
Memory Preset ISF Night
System
Model DHD4
Display Name D-73d
Output Resolution 1920x1080
Primary Serial Number 00000000
Serial Number 00000000
Boot Version 4.0
Firmware Version 4.0
Micro Version 4.0
BAE Serial Number 12345678
BAE Boot Version 1.0
BAE Firmware Version 1.0
BAE FPGA Version 1.0
Network
MAC Address 1A:2B:3C:4D:5E:6F
IP Address 192.168.0.150
Subnet Mask 255.255.0.0
Default Gateway 192.168.1.1
DHCP Enabled
Network Status Connected