Filter
Top Products
3-4
Connecting a RGB Analog source with composite sync.
RGB analog input terminals with composite sync input or with sync
on green. The projector detects automatically where the sync signal is
located.
Always use an interface when a computer and local monitor have to be
connected to the projector. Examples of interfaces which can be
applied :
RGBS or RGsB input selection
a. With the RCU: Select RGB in the Source Selection menu
b. With the local keypad :
(to gain access to the local keypad, see ‘Local keypad’in chap-
ter “Location and function of controls’.)
-Press ADJUST key, the General access menu is displayed on
the screen.
-Use the control disk to highlight 3.
-Press ENTER to select the highlighted source.
Connecting a RGB Analog source with Tri-level sync.
RGB analog input terminals with Tri level sync input or with
Tri-level sync on green. The projector detects automatically
where the sync signal is located.
RGB3S or RG3sB input selection
a. With the RCU: Select RGB in the Source Selection menu
b. With the local keypad :
(to gain access to the local keypad, see ‘Local keypad’in
chapter ‘Location and function of controls’.)
-Press ADJUST key, the General access menu is dis-
played on the screen.
-Use the control disk to highlight 4.
-Press ENTER to select the highlighted source.