Runco DTV-943 CRT Television User Manual


 
8-1
MESSAGES, WARNINGS, AND FAILURES
When selecting a new source,
information about this source
will be displayed on the screen.
Source number, horizontal and
vertical frequencies of the dis-
played source.
Announcement of the selected
source.
Message to enter your password.
Password contains 4 digits.
These messages will be dis-
played on the screen when push-
ing the TEXT key.
Text ON : the ‘bar scale indica-
tion’ will be enabled during the
change of an analog control in
the ‘operational mode’ + all
warnings and failures will be dis-
played.
Text OFF : the ‘bar scale indica-
tion’ will be disabled during the
change of an analog control in
the ‘operational mode’ + all
warnings and failures will not be
displayed.
Indication of the projector
address when activating the
‘ADDRESS’button on the RCU
with a pencil or other small
object.
The input is a valid input but the
source is not connected to the
input terminals or the input
source is switched off.
When a wrong key is pressed on
the RCU.
Message when the entered pass-
word is wrong.
End of adjustment range.
Message will be displayed when
the input source is no longer
available. The following mes-
sage then appears: ‘check input
signal or select new source’.
The entered frequency or applied
frequency of the source is out of
the projector’s range
Message to inform that selected
table is deleted. This message
will be followed by ‘confirm
message’, on which the user has
to answer.
Hardware failure. Call a quali-
fied service technician for repair.
Hardware failure. Call a quali-
fied service technician for repair.