Filter
Top Products
6-12
Vertical corners
Highlight ‘Vertical corners’and press ENTER to start the adjustment.
To make a coarse adjustment of the red or blue horizontal lines in zone 10,
14, 18 and 22 simultaneously.
Hint:
- Adjust until the red or the blue horizontal lines are on the green lines or
as close as possible to the green lines.
- During these adjustments, the horizontal convergence adjustments in
zones 10 to 25 will be set to midposition (barscale 50)
Fine Convergence Adjustments
Use these controls after coarse convergence adjustment to optimize the
convergence of the red and blue image on the green image.
Use the control disk to make horizontal or vertical convergence adjust-
ments in the selected zone and then press ENTER to move the box to
another zone or EXIT to return to convergence menu.
ENTER toggles arrow keys between zone selection and zone adjustment.
EXIT returns to convergence menu.
Note: The green convergence adjustments can be added as an option.
When these are available, always start with ‘green only’. This option will
also be indicated on the convergence menu.
Highlight first ‘Green only’when available with the control disk and press
ENTER to display the convergence adjustment menu.
Continue with red on green and blue on green.