Filter
Top Products
English - 131
Reference
Remote Control Unit
Read the table of contents and then
find and read the section describing
your problem, follow the instructions
given.
Plug your HDD &DVD RECORDER
off and on.
If the problem still persists, contact a
nearby Samsung service centre.
Checkpoint 1
Checkpoint 2
Checkpoint 3
Other problems.
Point the remote control at the remote
control sensor on your HDD & DVD
RECORDER. Allow for proper
distance. Remove obstacles between
your HDD & DVD RECORDER and
the remote control.
Check whether the batteries are
empty.
Check for the TV/DVD selection
button.
Check whether TV control button is
selected or not.
Checkpoint 1
Checkpoint 2
Checkpoint 3
Checkpoint 4
The remote control doesn't work.
A recorded disc is played with only
the subtitle and the audio signal
which were selected during recording.
Checkpoint 1
Is it possible to change a subtitle and an audio
signal on a recorded disc?
Other
Press and hold the button on the
front panel of the Recorder for more
than 5 seconds with no disc in the
unit. All settings including the
password will revert to the factory
settings. Do not use this unless
absolutely necessary. (Note that this
function is possible only when no disc
is inserted.)
Checkpoint 1
I forgot my password for parental supervision.
Checkpoint 1
Abnormal HDMI output screen.
If snow noise appears on the screen,
it means that TV does not support
HDCP (High-bandwidth Digital
Content Protection).
Checkpoint 1
Checkpoint 2
HDMI output Jitter
Check your TV system setup
correctly.
Please refer to the user’s manual of
your TV.
10-00000A-XEU_128-133_Refere 2005.6.20 3:6 PM Page 131