Samsung DVD-R155 DVD Recorder User Manual


 
78 - English
Additional
Information
Re-check the recording time and the
end time settings again.
Recording will be cancelled, if the
power is disconnected due to a
power failure or other similar reason,
while recording.
Checkpoint 1
Checkpoint 2
Timer recording does not work properly.
Timer Recording
Check if there is enough space in the
disc for recording.
Check whether the current disc is
recordable or not.
Make sure to check before the start
time of recording.
Checkpoint 1
Checkpoint 2
Timer lamp flickers.
If snow noise appears on the screen,
it means that TV does not support
HDCP (High-bandwidth Digital
Content Protection).
Checkpoint 1
Abnormal HDMI output screen.
HDMI
Check to see that the Video output is
HDMI enabled.
Check the connection between the
TV and the HDMI jack of the DVD
Recorder.
See if your TV supports this
480p/720p/1080i DVD Recorder.
Checkpoint 1
Checkpoint 2
Checkpoint 3
No HDMI output.
Check your TV system setup
correctly.
Screen Jitter may occur when the
frame rate is converted from 50Hz to
60Hz for 720p/1080i HDMI (High
Definition Multimedia Interface)
Output.
Please refer to the user's manual of
your TV.
Checkpoint 1
Checkpoint 2
Checkpoint 3
HDMI output Jitter
Remote Control Unit
Point the remote control at the remote
control sensor on your DVD recorder.
Allow for proper distance. Remove
obstacles between your DVD recorder
and the remote control.
Check whether the batteries are
empty.
Checkpoint 1
Checkpoint 2
The remote control doesn't work.
Other
Press the ( ) and ( ) buttons on
your DVD recorder simultaneously
when the power is on. All settings
including the password will revert to
the factory settings. Do not use this
unless absolutely necessary.
(Note that this function is possible only
when no disc is inserted.)
Checkpoint 1
I forgot my password for parental supervision.
A recorded disc is played with only
the subtitle and the audio signal
which were selected during recording.
Checkpoint 1
Is it possible to change a subtitle and an
audio signal on a recorded disc?
Read the table of contents and then
find and read the section describing
your problem, and follow the
instructions given.
Turn your DVD recorder off and on.
If the problem still persists, contact a
nearby Samsung service center.
Checkpoint 1
Checkpoint 2
Checkpoint 3
Other problems