Special Features
48
Setting Up Your Remote Control
This TV’s remote control can operate almost any VCR, cable box, or DVD. After it has been set up
properly, your remote control can operate in four different modes: TV, VCR, Cable, or DVD.
Pressing the corresponding button on the remote control allows you to switch between these modes,
and control whichever piece of equipment you choose.
Note
The remote control might not be compatible with all DVD Players, VCRs and Cable boxes.
Setting Up the Remote to Operate Your VCR
1
Turn off your VCR.
2
Press the MODE button and make sure
that the VCR LED is illuminated.
3
Press the Set button on your TV’s remote
control.
4
Using the number buttons on your remote
control, enter three digits of the VCR
code listed on page 47 of this manual
for your brand of VCR. Make sure you
enter three digits of the code, even if the
first digit is a “0”. (If more than one code
is listed, try the first one.)
5
Press the Power button on the remote
control. Your VCR should turn on if your
remote is set up correctly.
If your VCR does not turn on after set up,
repeat steps 2, 3, and 4, but try one of
the other codes listed for your brand of
VCR. If no other codes are listed, try
each VCR code, 000 through 089.
Note on Using Remote Control Modes: VCR
•When your remote control is in “VCR” mode, the volume buttons still control your TV’s volume.
BP68-00030A-4 4/15/05 8:34 PM Page 48