Filter
Top Products
49
Setting Up the Remote to Operate Your Cable Box
1
Turn off your cable box.
2
Press the MODE button and make sure
that the Cable LED is illuminated.
3
Press the SET button on your TV’s remote
control.
4
Using the number buttons on your remote
control, enter three digits of the cable
box code listed on page 47 of this manu-
al for your brand of cable box. Make
sure you enter three digits of the code,
even if the first digit is a “0.” If there is
more than one code listed, try the first
one.
5
Press the Power button on the remote
control. Your cable box should turn on if
your remote is set up correctly.
If your cable box does not turn on after
set up, repeat steps 2, 3, and 4, but try
one of the other codes listed for your
brand of cable box. If no other codes
are listed, try each code, 000 through
077.
Note on Using Remote Control Modes: Cable Box
•When your remote control is in “Cable Box” mode, the volume buttons still control your TV’s vol-
ume.
BP68-00030A-4 4/15/05 8:34 PM Page 49