67
Changing the Picture-in-Picture Channel
After you set the PIP signal source (antenna or cable), it is easy to change channels.
1
Press the Menu button. Move
the joystick down to select
PIP, then press the joystick to
enter. Quick way to access PIP
channel: Just press “PIP CH
(▲,▼)” on the remote control.
2
Move the joystick down to
select “Channel”.
3
Move the joystick to the right
or left to change the channel
of the PIP image.
4
Press Menu to exit.
NOTE
• The PIP channels are not available when RF is set to ANT-B.
(The PIP channels link to ANT-A).
BP68-00030A-4 4/15/05 8:34 PM Page 67