Filter
Top Products
English - 18
Using the “
-
” Button
The
-
button is used to select stations that broadcast a digital signal.
For example, for Channel 7-1, press 7, then -, and then 1.
➢
HD indicates the TV is receiving a Digital High Definition signal.
SD indicates the TV is receiving a Standard Definition signal.
➢
For quick channel change, press the number buttons, then press the ENTER button.
Using the PRE-CH Button to select the Previous Channel
Press the PRE-CH button.
The TV will switch to the last channel viewed.
➢
To quickly switch between two channels that are far apart, tune to one channel, then use
the number button to select the second channel. Then use the PRE-CH button to quickly
alternate between them.
Adjusting the Volume
Press the VOL + or VOL – button to increase or decrease the volume.
Using the MUTE Button
At any time, you can cut off the sound using the MUTE button.
1 Press the MUTE button and the sound cuts off.
The word Mute will appear in the lower-left corner of the screen.
2 To turn mute off, press the MUTE button again, or simply press the VOL + or VOL – button.
Viewing the Display
The display identifies the current channel and the status of certain audio-video settings.
Press the INFO button on the remote control.
The TV will display the channel, the type of sound, and the status of certain picture and sound
settings.
Press the INFO button once more or wait approximately 10 seconds and it disappears
automatically.
Air 28
Mono
Picture Mode : Dynamic
Sound Mode : Custom
MTS : Mono
Caption : Off
V-Chip : Off
12 : 00 am