Filter
Top Products
English - 20
4 Press the ▲ or ▼ button to select Analog or Digital, then press the ENTER button.
You can select the correct signal source among STD, HRC and IRC by pressing the
▲ or ▼ button, then press the ENTER button.
To memorize the channels, press the ▲ or ▼ button to select Start, then press the
ENTER button.
➢
If you have Digital cable TV, select the signal source for both Analog and Digital.
➢
STD, HRC, and IRC identify various types of cable TV systems. Contact your local
cable company to identify the type of cable system that exists in your particular area.
At this point the signal source has been selected.
5 The TV begins memorizing all available stations.
When pressing the ENTER button during a storing process, the Stop Auto Program?
message will be displayed. Select Yes by pressing the ◄ or ► button.
Press the EXIT button to exit.
➢
The TV must be connected to an antenna/cable in order to receive digital TV signals.
Even if a particular channel is deleted from the memory, you can always tune to that
channel directly by using the number buttons on the remote control.
➢
• All available DTV and analog channels are automatically stored in memory.
• It takes approximately 3 to 10 minutes to memorize channels.
Auto Program
Auto Program in Progress.
15%
Air 16
Enter
Stop
Auto Program
Stop Auto Program?
15%
Enter
Yes No
Move
Auto Program
Selects a cable signal type for your location.
Analog
Start
STD
HRC
IRC
Digital
STD
HRC
IRC
Enter
Return
Move
Return
Return