Filter
Top Products
English - 13
Connecting a Satellite Receiver or Decoder
In order to watch television programmes broadcast via a
satellite network, you must connect a satellite receiver to
the back of the TV. Also, in order to descramble a coded
transmission signal, you must connect a decoder to the
back of the TV.
◆ Using a SCART cable
Connect the receiver (or decoder) SCART cable to one
of the SCART connectors at the back of the television.
◆ Using a coaxial cable
Connect a coaxial cable to the:
-
Receiver (or Decoder) output socket.
-
Television aerial input socket.
➢ If you wish to connect both a satellite receiver
(or decoder) and a VCR, you should connect the:
◆ Receiver (or Decoder) to the VCR
◆ VCR to the television
Otherwise, connect the receiver (or decoder) directly
to the television.
TV Rear View
Satellite receiver/Decoder
To view television channels correctly, a signal must be received by
the set from one of the following sources:
◆ An outdoor aerial
◆ A cable television network
◆ A satellite network
1 In the first three cases, connect the aerial or network input cable to
the 75Ω coaxial socket at the back of the television.
2 If you are using an indoor aerial, you may need to adjust it when
tuning your television until you obtain a picture that is both sharp
and clear.
For further details, refer to:
◆ “Storing Channels Automatically” on page 18.
◆ “Storing Channels Manually” on page 20.
Connecting to an Aerial or Cable Television Network
TV Rear View
Cable Television
Network
or
BN68-00746A(GAIA2_Euro_ENG) 2004/08/23 03:54 PM Page 13