Filter
Top Products
English
General settings
63 How to set
These settings are used to control the operating display
area of the monitor, to display the date, time and other
information. Normally all indicators are displayed, but
they can be hidden, if needed.
"VIDEO LOSS" can be set to be displayed when a camera
video is interrupted due to an unexpected problem, or a
lamp connected to the rear panel control terminals can
be turned on.
1
Display the <DISPLAY SET> screen as explained in
"Displaying the general settings screen", and then
turn the S-dial clockwise. (P62)
The "ON" indicator on the DATE line starts blinking.
2
Turn the J-dial, set the DATE to "OFF", and then
turn the S-dial clockwise.
Repeat the same procedure for each item you want to
hide from the display.
b The operating display area after setting the
items "ON".
3
Turn the J-dial, select "VIDEO LOSS", and turn the
S-dial clockwise.
The "ON" field starts blinking.
Normally this is set to display. If necessary, turn the
J-dial and hide it by setting it to "OFF".
4
Turn the S-dial clockwise.
5
Press the EXIT/OSD button.
☞ Cancelling the VIDEO LOSS detection
• Connect a normal video signal.
• If video signal connection is not necessary, then press the
camera selection button where the VIDEO LOSS was
detected, and then press the same camera selection
button again for about 3 seconds.
A Data display settings/VIDEO LOSS settings
MENU
(J)
(S)
<DISPLAY SET>
DATE : ON
TIME : ON
QUALITY : ON
AUDIO : ON
ALARM COUNT : ON
ALARM TYPE : ON
TITLE : ON
VIDEO LOSS : ON
1.DISPLAY SET
3.GENERAL SET
<MAIN MENU>
<GENERAL SET>
01-01-06 00:00:00 REC REPEAT EN A ALARM 0000
<DISPLAY SET>
DATE : OFF
TIME : OFF
QUALITY : OFF
AUDIO : OFF
ALARM COUNT : OFF
ALARM TYPE : OFF
TITLE : OFF
VIDEO LOSS : ON
1
3
5
7
2
4
6
02
12
7
3465
01-01-06 00:00:00 REC REPEAT EN A ALARM 0000
(J)
(S)
<DISPLAY SET>
DATE : ON
TIME : ON
QUALITY : ON
AUDIO : ON
ALARM COUNT : ON
ALARM TYPE : ON
TITLE : ON
VIDEO LOSS : ON
EXIT/OSD
L8HBM_XE(HARD)(GB).book 63 ページ ２００６年２月６日 月曜日 午前１０時５２分